Axial SCX-10 Hurtz V2 disconnector system (DIG) by Vanquish Pr.

Vanquish Products Hurtz Shifter 3 Position Dig Unit for the Axial AX-10 or SCX-10 (by reversing the transmission).

• Dig unit was designed to be a heavy duty unit for demanding pro drivers.
• The unit features many details that eliminate known problems for failure.
• ALL drive drive dogs are 440c stainless steel including stationary dogs mounted to the housing.
• Sliding mechanisms will not show galling, so only a small amount grease is needed.
• Stationary rear drive output does not slide in and out of housing.
• Unit weighs in at 80 grams or .180 lbs.
• Servo mount is located on the dig housing so most servo flex is eliminated.
• Hurtz Shifter lever action give a mechanical advantage for the servo of 2.5 to 1 ratio. allowing a standard servo to man handle the shifting demands needed in competition crawling.
• Total shifter travel needed to shift to all three positions is .73 inches.
• Mini Servo Mount now avalable
• ** Regular servo mount can use a HITEC HS-5625MG, HS-645MG, or Futaba S3305.
• ** MINI mounts can run a HITEC HS-225MG.
• ** Rene B. recomends a HITEC HS-5245MG, this one allows you to run both radios in all modes.